PSC DUET User Manual download pdf (Page 9)

R44-2006 5

INTRODUCTION

SCANNER PROGRAMMING MODE OVERVIEW

To change the features on your scanner, go to

Section 2 – Scanner Programming and scan the

desired bar codes, using these procedures:

• Enable the Scanner Programming Mode by

scanning the SWITCH bar code on page

52. (The LED indicator lamp will flash

continuously ON and OFF to indicate the

scanner has entered the Scanner Program-

ming Mode).

• Scan the bar code labels on pages 55

through page 70, to enable or disable the

desired features. (The VS and HS scanners

will beep once at each scan to indicate a

"good read", whereas, the Duet will emit

multiple beep tones).).

• Scan the SWITCH bar code on page 52 a

second time to Exit the Scanner Program-

ming Mode. (The scanner will reset, emit

a single power-up beep, and the LED

transitions to a steady ON condition).

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 79 80

Comments to this Manuals

No comments