PSC FALCON 315 User's Guide download pdf (Page 32)

Falcon Basics

8 Falcon

DOS Portable Terminals

10. Replace the battery-compartment cover by inserting the bottom tab into

the slot and rotating the cover latch in a clockwise direction.

11. Replace the hand-strap hook on the connector at the base of the unit.

Falcon Models 34x

To replace the batteries for Falcon model 34X, complete the following steps:

1. Turn the Falcon off.

2. If using the hand-strap rather than the pistol grip, detach the elastic

hand-strap by releasing its hook from the hand-strap connector at the

base of the unit.

3. Turn the cover latch dials to release the battery compartment cover.

Refer to Figure 8 on page

10 for the location of the dials.

• Using the lever, turn the left dial clockwise.

• Using the lever, turn the right dial counter-clockwise.

4. Pull the end of the exposed plastic ribbon in the battery compartment

until the batteries pop out.

5. Lay the plastic ribbon along the bottom of the battery compartment

with the end sticking out.

6. Find the positive (+) and negative (-) symbols on the

NiMH Battery

Pack’s

label.

7. With the label side out, tilt the positive end of the pack into the upper

end of the battery compartment.

8. Firmly press the negative end until it is fully inserted into the battery

compartment.

9. Place the plastic ribbon underneath the battery-compartment cover.

The Falcon 33X will not function unless the battery-compartment cover is in place

and securely latched.

The battery pack should not be replaced in a dirty or harsh environment. When the

battery compartment cover is off, dust or moisture can potentially cause damage.

Falcon models 33x and 34x will not function unless the battery-compartment cover

is in place and securely latched.

2314.book Page 8 Wednesday, June 9, 2004 8:30 AM

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 115 116

No comments

PSC FALCON 315 User's Guide Page 32