Euro Cart Compact Equipment Cart Made in the USA Operation Manual Version 1.0 Copyright 2013 Professional Sound Corporation Printed in the U.S.A.
14. Locate the small shelf and four (4) of the ¼-20 LONG Thumb Screws. Position the shelf in your desired location and gently start the thumb sc
17. Locate the two (2) Cable Hooks and two (2) of the ¼-20 SHORT Thumb Screws. Place the thumb screws through the hole in the cable hook and atta
18. Your PSC EuroCart is now fully assembled. It is now time to go back and tighten up all of the thumb screws you have previously installed. Re
2. ANTENNA MOUNTS PSC also offers optional RF antenna mounting bars. These antenna mounting bars can be used with or without the rack mount
3. CARPET AND MOLDING PSC offers an optional carpet and molding kit for the PSC EuroCart. This kit provides a soft carpet covering for all
4. POWERSTAR EUROLIFE The new PSC PowerStar EuroLiFE is based on our very successful PowerStar LiFE. This new unit was designed to complement our ne
PSC RECCOMENDATION: PSC recommends that you periodically check and tighten all of the thumb screws. WARNING! THE PSC EURO CART IS MADE OF METAL
LIFTING INSTRUCTIONS: This PSC EuroCart has been designed to be as light weight as possible for your convenience in the field. Because of this light
SPECIFICATIONS: Size: 37” Tall x 19” Wide x 21” Deep (94cm x 48cm x 53cm) Self Size: Small Shelf 14.5” Wide x 10” Deep (36.8cm x 25.4cm)
Thank you for purchasing the Professional Sound Corporation Euro Cart. PSC is confident that the Euro Cart has set new standards in design for a com
DESCRIPTION: This new PSC Euro Cart is our modern interpretation of our industry standard PSC sound cart. We have been building our existing sound ca
PARTS IDENTIFICATION: Before you start assembly of the PSC Euro Cart, please take a moment to make sure you understand and can identify all of the pa
ASSEMBLY: 1. Locate the “base” of the cart and sit in on the floor, upside down. 2. Locate the two rubber bumpers and thread them into the two th
5. Locate the “Hairpin” clips that are used to secure the wheels to the axels and install them on the outside of each wheel as shown in the photo bel
7. Locate the two (2) boom Cups with the two (2) of the ¼-20 SHORT Thumb Screws. Install the two boom cups by inserting the thumb screws though the
9. Locate and install two (2) of the 3/8-16 Short thumb screws into the back of the bottom uprights, tightening the two sections of the uprights to
11. Gently push the thumb screws through the holes in the upright rails ensuring that they line up with the threaded inserts in the shelf ears and j
Comments to this Manuals