PSC Scanners User Manual download pdf (Page 5)

Product Reference Guide 1

Installation

Keyboard Wedge

Complete the following steps:

1. Turn off the terminal or computer.

2. Disconnect the keyboard cable from the back of the terminal or

computer.

3. Connect the QS2500 to the terminal or computer using the appro-

priate interface cable.

4. Turn the terminal or computer back on.

RS-232

Complete the following steps:

1. Turn off the terminal or computer.

2. Connect the appropriate interface cable and, if you are not using a

power-off terminal (POT), the external power supply (DC adapter)

shipped with your QS2500.

3. Plug the serial connector into the serial port on the back of the com-

puter or terminal. (Tighten the two screws to secure the connector

to the port.)

4. Plug the power pack into the power source.

5. Turn the terminal or computer back on.

NOTE

If the QS2500 does not operate, turn off the terminal or computer immediately

and check all connections. If necessary, go through the above steps again.

1 2 3 4 5 6 7 8 9 10 ... 65 66

No comments

PSC Scanners User Manual Page 5